Is The Hayward Super Pump Quiet?

hayward super pump


One of the main reasons why customers love the Hayward super pump is its low-level noise. It has the high-performance motor of an AO Smith motor.

UltimateOutdoorLiving.com is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees. This means we get a commission for any qualifying purchases.

What Customers Are Saying About the Noise Level Of the Hayward Super Pump

“It seems pretty quiet almost impossible to hear from 20 feet away” Amazon.com 

“Very quiet and I’m running it 24/7”  Doheyny.Com

“Works perfectly and the motor is much quieter than the old one” Inyopools.com

Looking After The Hayward Super Pump – Extending Your Swimming Pool Pump’s Life

No matter what pump you buy, remember that there is a level of wear and tear to these machines and they will get louder in time than when you first bought them.

To make them last longer and run quieter for a long time, make sure you properly install and maintain a pool pump.

  1. Get the pool’s water level halfway up the skimmer box.
  2. Regularly clean out the pump. On windy days, clear out the debris/leaves in the strainer basket regularly.
  3. Place Your pump on a level surface.
  4. Always check that air vents are free from obstruction.

When A Pump Begins To Get Noisy

Once you notice that your pump is getting noisier than it used to be, check it immediately. There are many reasons why a swimming pool pump gets noisier in time so it’s best to check it as soon as possible to stop the problem from getting worse.

Here are a few reasons why a quiet Hayward Super pump may start to get noisy:

  • Cavitation
  • Problem with the bearings
  • airflow obstruction
  • Loose debris in the pump housing

The Hayward Pool Pump Manual Advices the Following For Noisy Hayward Super Pumps

1. Air leak in suction piping, cavitations caused by restricted or undersized suction line or leak at any joint, low water level in the pool, and unrestricted discharge return lines.

Solution: Correct suction condition or throttle return lines, if practical. Holding hand over return fitting will sometimes prove this point or putting in a smaller eyeball fitting.

2. Vibration due to improper mounting, etc.

Solution: Mount the pump on a level surface and secure the pump to the equipment pad.

3. Foreign matter in the pump housing. Loose stones/debris hitting the impeller could be the cause.

Solution: Clean the pump housing.

4. Motor bearings are noisy from normal wear, rust, overheating, or concentration of chemicals causing seal damage which will allow chlorinated water to seep into bearings wiping out the grease and causing the bearing to whine.

Solution: All seal leaks should be replaced at once.

And don’t forget to visit our guide to buying a swimming pool pump

Leave a Comment

This site uses Akismet to reduce spam. Learn how your comment data is processed.